Thread gestartet von playtime on scalemates.com
playtime 222
Calling anyone who owns any one of the boxings of this kit and a scanner. I've glued my wings together without opening the holes for the pylons. I would be very grateful if someone could scan the back of the kit part, either D1 or D2, and send me the pic?
Calling anyone who owns any one of the boxings of this kit and a scanner. I've glued my wings together without opening the holes for the pylons. I would be very grateful if someone could scan the back of the kit part, either D1 or D2, and send me the pic?
10 February 2017, 18:37
playtime 222
Bump. Well... any scan of a wing with the 2 pylon holes in? I can scale it down.
Bump. Well... any scan of a wing with the 2 pylon holes in? I can scale it down.
12 February 2017, 13:21
gorby
Sorry playtime I can't help, but when I did this a while ago, I found that shining a very bright light through the wing made the drill points visible. If you have tried that, at least this will bump your post to the top
Sorry playtime I can't help, but when I did this a while ago, I found that shining a very bright light through the wing made the drill points visible. If you have tried that, at least this will bump your post to the top
12 February 2017, 16:34
playtime 222
Not bright enough apparently! May have to take it apart and clean up any mess. What's the solvent for this again - liquid cemented pieces - brake fluid?
Not bright enough apparently! May have to take it apart and clean up any mess. What's the solvent for this again - liquid cemented pieces - brake fluid?
15 February 2017, 10:35
playtime 222
I'm reading here (cs.finescale.com/fsm..s/f/13/t/147764.aspx) that cutting is my only real option...
I'm reading here (cs.finescale.com/fsm..s/f/13/t/147764.aspx) that cutting is my only real option...
15 February 2017, 10:37
gorby
That's a shame, maybe the plastic is thicker than the kit it did it on. Good luck.
That's a shame, maybe the plastic is thicker than the kit it did it on. Good luck.
15 February 2017, 10:41